|
Shift Cable Removal, Installation, and Adjustment
|
|
 Where icon is shown, click for further information. | |
|
|
Do not bend the shift cable excessively. | |
2. |
Center Maintenance Cover - Remove |
4. |
Shift Cable (Shift Lever Side) - Remove |
9. |
Shift Cable Bracket - Remove |
10. |
Shift Cable (Under Side) - Remove |
|
|
 Where icon is shown, click for further information. | |
|
|
Do not bend the shift cable excessively. | |
|
|
Unless otherwise indicated, illustrations used in the procedure are for LHD model. | |
1. |
Shift Cable (Under Side) - Install |
2. |
Shift Cable Bracket - Install |
|
NOTE: Make sure the control pin (A) is inserted through the shift cable end (B) and fully seated on the control lever (C).
| |
|
NOTE: Make sure the lock pin (A) is inserted through the control pin hole (B) to the opening (C) of the control lever (D) so that the hooked end (E) of the lock pin locks into the control pin hole.
| |
8. |
Shift Cable (Shift Lever Side) - Install |
9. |
6.0 mm (0.236 in) Pin - Remove |
10. |
All Removed Parts - Install |
11. |
Shift Cable - After Install Check |
NOTE: Do not bend the shift cable excessively. |
1. |
Center Maintenance Cover - Remove |
3. |
Shift Cable (Shift Lever Side) - Disconnect |
5. |
All Removed Parts - Install |
6. |
Shift Cable - After Adjust Check |
|